slim design, full-scale sound
The new Certaldo series 2 is a mostly re-thought and re-designed system which takes the performance of our slim design floorstander up to the next level. It definitely performs out of its physical size. It already did, but now in an even more seductive and elegant way.
Certaldo series 2 inherits the hybrid rear/down firing loading system of the previous version and further develops it.
Enclosure volume was increased around 10% and in order to obtain a greater low-end octave authority and reduced distortion the 5.25” mid-woofers were re-engineered focusing on the motor venting system and suspension material.
An additional improvement was also provided by the underneath aluminium port with its redesigned and enlarged gradual flaring which contributed to the overall over-damped yet powerful bass performance.
Certaldo series2 implements a totally re-engineered crossover circuit which provides a more extended low frequency emission, a higher efficiency and a practically ‘resistive’ impedance which makes it possible to pair this model with a wide range of electronics.
The use of top quality components like the custom Rosso capacitors made by ClarityCap, thick film resistors and our new made in Italy inductors adds that extra touch of refinement and dynamics to the full sound of this speaker.
A simple, clean and slim design with a refined soul, visually underlined by its precious construction details.
A slim, elegant floorstander designed to blend in style into your home with a surprising acoustic presence usually found in a much larger speaker.
Technical specifications
Type
2.5 -way rear/down firing ported floorstanding system
Sensitivity
88 dBspl (2.83V, 1m)
Nominal impedance
8Ω (minimum 5Ω)
Drive units
- 1 x ø 25mm (1 in) silk dome neodymium tweeter
- 1 x ø 130mm (5.25 in) glass fibre composite cone mid-range
- 2 x ø 130mm (5.25 in) glass fibre composite cone mid-woofer
Frequency response (±3dB)
40 Hz – 30 kHz (typical in-room bass resp. -6dB @35Hz)
Crossover frequencies
200 Hz – 2.5 kHz
Recommended amplifier power
50W – 150W into 8Ω with unclipped sound signal
Cabinet
solid HDF fiberboard, aluminium front and side panels, internal damping pads
Dimensions
- Height: 1075mm (42.3 in) incl. plinth and spikes
- Width: 194mm (7.6 in) | 237mm (9.3in) including plinth
- Depth: 262mm (10.3in) | 303mm (11.9in) including plinth
Net weight
28 Kg (61.7 lb) each
Cabinet finish
- exclusive RF silky matt black coating
- black carbon fibre pattern leather (front panel and side stripes)
Side panels
- black high gloss lacquer
- real walnut veneer
- other finishes on request